Fileshare

3-D Model Prototype

Gaahleri Swallowtail -SD Airbrush Holder
No supports needed
File Format: STL Zipped

EIBOS Filament Dryer Series X Tetras
Desiccant Chamber Plug

Has anyone else wondered what to do about the desiccant holders in the Bambu X1C when installing the Eibos Tetras filament dryer? The whole idea behind the dryer is to isolate the 4 different chambers so that different drying conditions could be achieved for different types of filament; however, the chambers can not be isolated because the desiccant holders at the bottom span the adjacent chamber causing heat and humidity creeping. Filling them with Bambu pouches or filling them with desiccant just doesn't seem to be logical.

Zip file contains the .stl and the .3mf (Orca Slicer) files. Printed it in ASA due to it's resistance to heat. ABS might be just as good but PLA is out of the question.

Please share what you think and if it works for you. If all goes well I'll share it with the community.